The TC-510 Pressure Control Unit is a passive interface between the Millar Mikro-Tip catheter pressure transducer and strain gauge pressure monitors which supply bridge excitation voltage and have balance and calibration controls for full-bridge strain gauge pressure transducers. The TC-510 has an internal calibration circuit to provide an electrical zero as well as a 100 mmHg calibration signal. The output connector is a standard 9-pin sub-D. A separate monitor interface cable is required.
Download Brochure
** If replacing a TCB-500 or TCB-600 control unit, the PCU-2000 control unit is required. The TC-510 is a passive control unit and must be connected to a bridge amplifier.
Pressure Control Unit Ordering Information
Model Number
Part Number
Number of Channels
Input Connector Type
Isolated Input/Output
Output Connector Type
CE Approved
TC-510
851-5918
One
Viking
No
9 pin sub-D
Yes
NOTE: Viking connectors are round with 4 pins.
Mikro-Tip Catheter Pressure Interface Cables Mikro-Tip Pressure Catheters are provided with
either Viking (4-pin) or Millar Low Profile (4-pin) connectors depending
on the model purchased. Catheter models with Viking connectors may connect
directly to the TC-510.
Connecting the catheter with a Viking connector directly to the control
unit limits access to the subject or patient. It is recommended that
a TEC-10C interface cable be used between the catheter and control unit.
All catheters with low profile pressure connectors require a TEC-10D
interface cable to the control unit. Each pressure channel requires
a separate interface cable and control unit.
NOTE: Viking connectors are round with 4 pins.
Low Profile connectors are flat with 4 pins. The above flexible cables facilitate
maneuvering the catheter during recording. They may be sterilized and permit
connection of a catheter to a Pressure Control Unit located outside the
sterile field.
TC-510 Pressure Control Unit Output Cable
Cable Model
Part Number
Cable Length
Control Unit
Connector Type
Monitor Connector Type
TC-510 Output Monitor Cable
850-3008
6.5 ft. (198 cm)
9 pin sub-D
Open ended, not wired
NOTE: A selection is available from Millar of
other TC-510 output cables that are wired for a variety of monitor and recorder
inputs. Please contact our Customer Service Department for availability.
When ordering please specify the following:
Data Acquisition System/Recorder/Preamp/Coupler manufacturer.
Example: Hewlett Packard
Preamp/Coupler models. Example: 8805D
Specify Connector and pin-out. Example: Hewlett Packard
TWINAX or Cannon WK6-21C
Indicate if an intermediate connector panel, i.e.,
“patch panel,” is to be used with the recorder.
TC-510
connectivity
Millar
Instruments, Inc. | 6001-A Gulf Freeway Houston,
Texas 77023-5417 USA | 832.667.7000
Home
Distributor 
Contact
Site
Map
